FUJI & CO.(Piezo Science)

Home Info Request Feedback Search



Ultra Sensitive DLATGS Detector FTS110CA

The DLATGS element is used for detection when extreme sensitivity is required that cannot be achieved using normal PZT sensors. The DLATGS element has 5 to 8 times the sensitivity of PZT. 

The FTS110CA has a 4.35m bandpass filter well suited for long range flame and gas (CO2) detection.



Values Unit Condition
Element size 1.5 dia. mm  
Signal Sensitivity typ. 34 mV p-p 500K, 1Hz
Noise typ. 250 mV p-p 25C, x5000
Source voltage 0.38 ~ 1.3 V 25C
Supply voltage 2.0 ~ 10 V  
Load resistor 10 ~ 1,000 kOhm  
Operating temp. -10 ~ 40 C  
bulletThe sensor is better adapted where ambient temperature variation is small.
bulletBecause of usage, a constant temperature environment is recommended.
bulletOperation at ambient temperatures above 40C is not recommended. Curie point: 55C

        Note: These specifications are subject to change without notice.

        Back to top


Send mail to webmaster with questions or comments about this web site.
Send mail to Fuji & Co. with questions or comments about products and services.
Last modified: October 25, 2009